Mohamed Aburaia, Christoph M. Bucher, Maximilian Lackner, Joamin Gonzalez-Gutierrez, Haiguang Zhang and Herfried Lammer
Consumer Fused Filament Fabrication (FFF) desktop 3D printers are used for prototyping, spare parts and even smallscale production, but produce parts with lower tensile strength than traditional manufacturing methods. High tensile continuous fibers increase filament composite strength, but poor fiber adhesion and pull-out are common weaknesses. The few commercially available continuous fiber reinforced (CFR) filaments are costly and only compatible with their manufacturer’s machines.
This work describes the development of a method and a prototype apparatus to produce standardized CFR filament, addressing the weaknesses of CFR thermoplastics while maintaining their compatibility with consumer 3D printers, and thereby achieving mechanical properties required for costeffective small-scale productions.
A bundle of raw carbon fiber is impregnated with a solution of thermoplastic and compatible solvent, improving the adhesion of the fibers to the thermoplastic and reducing fiber pull-out. The pretreated fiber is then extrusion-coated with thermoplastic to achieve a standardized filament diameter. 1.75 mm PLA filament reinforced with 12k continuous carbon fiber and pretreated with an ABS- Acetone solution was produced.
Parts and products ranging from small consumer goods to meter- sized airplane wing sections were successfully printed using a standard FFF extruder. Tensile tests showed a yield stress increase of 535% compared to plain PLA, and a 70% increase compared to filament produced with raw, untreated fibers. Further work is needed to determine the ideal fiber content, its distribution within the filament and the concentration of the solution.
English 
Spanish 
Chinese 
Russian 
German 
French 
Japanese 
Portuguese 
Telugu